• $18.00 S&H

    Tape Push Tool

    The Tape Push Tool is used to advance the component tape onto the sprocket wheel. This tool is recommended for use with all tapes.

  • Essemtec Feeder Finger

    Essemtec Feeder Finger

    The Essemtec Feeder Finger Solution is in Development.

     

    Weight 7 lbs
    Dimensions 14 x 12 x 6 in
  • Juki RF08FF Feeder Finger

    Juki Feeder Finger products are distributed exclusively by Juki Automation Systems, Inc.

     

    Contact your Juki representative for more information.

     

    Weight 7 lbs
    Dimensions 14 x 12 x 6 in
  • Juki EF08FF Feeder Finger

    Juki EF08FF Feeder Finger

    Juki Feeder Finger products are distributed exclusively by Juki Automation Systems, Inc.

     

    Contact your Juki representative for more information.

     

    Weight 7 lbs
    Dimensions 14 x 12 x 6 in
  • Juki CF08FF Feeder Finger

    Juki CF08FF Feeder Finger

    Juki Feeder Finger products are distributed exclusively by Juki Automation Systems, Inc.

     

    Contact your Juki representative for more information.

     

    Weight 7 lbs
    Dimensions 14 x 12 x 6 in
  • Juki AF05FF Feeder Finger

    Juki AF05FF Feeder Finger

    Juki Feeder Finger products are distributed exclusively by Juki Automation Systems, Inc.

     

    Contact your Juki representative for more information.

     

    Weight 7 lbs
    Dimensions 14 x 12 x 6 in
  • $75.00 S&H

    Tape Dent Tool

    The Tape Dent Tool is used to crimp the component tape before inserting it into the Feeder Finger. The moon shaped dent allows the blade to quickly penetrate and separate the cover tape from the component tape.

  • Panasonic CM Feeder Finger

    Panasonic CM Feeder Finger

    The Panasonic CM Cut Tape Solution is in Development.

     

    Package Weight 7 lbs
    Dimensions 14 x 12 x 6 in
  • Samsung SME Feeder Finger
    $1,600.00

    Samsung SME Feeder Finger

    For Samsung SME Electric Feeders

    8 Feeder Fingers per case

     

    The SME Feeder Finger Solution is designed to work with the Samsung SME Electric Feeder to improve the feeders efficiency and significantly reduce feeder setup and change over time. The operator now can feed cut component tape as short as three inches or a full reel. Merely push the component tape into the feeder and place it onto the pick and place. A tape leader is no longer required, and no parts are lost on the initial feed of tape.

     

    Reduce production setup time by fifty-percent with the SME Cut Tape Feeder Finger Solution.

     

    Key benefits:

    • Attaches easily to your existing feeder
    • Handles cut tape as short as three inches
    • Eliminates splicing
    • Loads in less than 5 seconds
    • Eliminates cover tape jams
    • Reduces setup time by fifty-percent
    Cut Tape Feeder Finger Specification
    Typical components 0201 / 1206
    Tape Width 8 mm
    Tape depth (feeder type) 2.5 mm (8 mm)
    Tape material Paper Tape only
    Full Reels or Cut Tape Yes
    Weight 7 lbs
    Dimensions 14 x 12 x 6 in